Age | Commit message (Collapse) | Author |
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
GENERIC allows to use 0MQ as a dumb networking framework.
It provides user with connect/disconnect notifications.
Also, each inbound message is labeled by ID of the connection
it originated from. Outbound messages should be labeled by
the ID of the connection to send them to.
To distinguish connect/disconnect notifications from common
messages, COMMAND flag was introduced.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
This patch simplifies the whole codebase significantly,
including dropping depedency on libuuid.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
It was used only by ROUTER socket. After its removal it became
obsolete.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
To be replaced by new generic socket type
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
As PGM is not capable of passing subscriptions upstream,
subscriptions are ignored at sub side and engine subscribes
for all messages on pub side.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
The filtering is now done depending on the socket type. SUB socket
filters the messages (end-to-end filtering) while XSUB relies
on upstream nodes to do (imprefect) filtering.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Till now the VSM buffer was aligned to 16 bit boundary
which could possibly cause problems on RISC architectures
when accessing the message data in unsafe manner.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
|
|
recv function on eventfd signaler could accidentally
grab two signals instead of one. Fixed.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Eventfd (on Linux) is more efficient that socketpair
for passing simple signals.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Storing commands in OS socket buffers caused whole lot of
problems when free space in the buffer ran out. This patch
stores commands in ypipes instead and uses socketpair just
to signal the other thread, ie. at most one byte is stored
in the socketpair at any single instant.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
pthread_* functions return the error number rather than
setting errno. This was not accounter for till now.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
IPv6 addresses have colons and will produce invalid data for the getaddrinfo lookup.
Signed-off-by: Andrew Thompson <andy@fud.org.nz>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
So far the requests in req/rep pattern were delivered to and processed
by worker even though the original requester was dead. Thus,
the worker processing replies with noone to deliver results to.
This optimisation drops requests in two situations:
1. Queued inbound requests in XREP socket when peer disconnects.
2. Queued outbound requests in XREQ when socket is closed.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Up to now the complexity of fair-queueing in XREP was O(n).
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
This patch introduces two changes:
1. 32-bit ID is used to identify the peer instead of UUID
2. REQ socket seeds the label stack with unique 32-bit request ID
It also drops any replies with non-matching request ID
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
So far there was no distinction between message parts used by 0MQ
and message parts used by user. Now, the message parts used by 0MQ
are marked as 'LABEL'.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
For the platforms that don't support MSG_DONTWAIT the reader
socket in mailbox_t was kept in non-blocking state and flipped
to blocking state and back when blocking read was requested.
Now, the state is preserved between calls and flipped only
if different type of operation (block vs. non-block) is
requested.
Signed-off-by: Fabien Ninoles <fabien@tzone.org>
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
When session is already terminating and reconnection happens at
that point, the session should not create new pipe to its socket.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
pipe_t now correctly drops pointer to the underlying pipe when
sending pipe_term_ack command.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
|
|
<steven.mccoy@miru.hk>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
- Add doc and tests
- Add options and setup
- Wait using poll/select
Signed-off-by: Fabien Ninoles <fabien@tzone.org>
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
This patch fixed the JIRA issue 223
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Fix windows.h included before winsock2.h.
Remove definition of _WINSOCKAPI_.
Signed-off-by: Steven McCoy <steven.mccoy@miru.hk>
|
|
This option is a performance tweak. In devices XSUB socket filters
the messages just to send them to XPUB socket which filters them
once more. Setting ZMQ_FILTER option to 0 allows to switch the
filtering in XSUB socket off.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
This patch will prevent duplicate matching in devices in the future.
Instead of matching in both XPUB and XSUB, it'll happen only
in XPUB. Receiver endpoint will still filter messages via SUB
socket.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|
|
Bug in previous refactoring fixed.
Signed-off-by: Martin Sustrik <sustrik@250bpm.com>
|